2016-09-26

The measurement of SF6 dew point meter has the following defects: A. Not online SF6 dew point meter is used for regular detection, which is a non-online detection method, and can not reflect the operating status and dynamic changes of the equipment in real time. The maintenance of equipment and the automation of power distribution network in the true sense cannot be realized.

2016-09-26

The purpose of using SF6 online monitoring equipment is to combine troubleshooting and prevention, to achieve reliability and low cost of consumption as the goal of advanced condition maintenance mode. The management, economic and social benefits it can bring are reflected in the following three aspects:

2016-09-24

WINFOSS-P6 micrometer adopts Finland VAISALA capacitive humidity sensor, capacitive medium is polymer collection film, so it is often called polymer film humidity sensor, the linear in the low humidity segment is better, it is composed of the upper and lower plate, the middle is polymer collection medium, the medium is Finland VAISALA company patented products, Polymer collection film is an organic medium, with the advantages of rapidly absorbing water and releasing water, but also an insulating

2016-09-21

With the rapid development of the power industry and the improvement of the technical level, SF6 gas monitoring and recycling technology has also developed rapidly, the corresponding management measures have also been introduced, the management is more scientific and standardized, so as long as the establishment and compliance with some basic preventive measures, the normal use of SF6 gas is safe. SF6 gas destroys ozone in the stratosphere. Among the thermo-humidity effects of various gases, SF6

2016-09-21

(1) First clean the SF6 electrical equipment connector and the instrument connector with a clean soft cloth. If conditions are available, use a hair dryer to blow the connectors and pipelines for 10 to 15 minutes, and then connect the instrument with the sf6 electrical equipment connector.

2016-09-21

(1) First clean the SF6 electrical equipment connector and the instrument connector with a clean soft cloth. If conditions are available, use a hair dryer to blow the connectors and pipelines for 10 to 15 minutes, and then connect the instrument with the sf6 electrical equipment connector.